Gutter Foam - Gutter Protection

• UV protected, open-cell polyurethane foam filter
• Prevents fallen leaves and tree debris from blocking gutters
• Seamless flow of water through the gutter system.
• Cleans water entering storage tanks
• Two sizes to fit different gutter profiles
• Installed or DIY

HOW TO INSTALL GUTTER FOAM:

STEP 1 - CLEANING

• Climbing on roofs & up ladders are high risk areas – consider using a qualified installer.
• Make sure that the ladder or platform you will be working off is safe and secure.
• Clean out the gutters & down-pipes with a scoop, brush and running water.
• This makes sure that they are free of leaves, debris and sludge.
• Make sure that your gutters are clipped into the brackets and have the correct fall towards the down pipe outlets.
• Incorrect fall to the down-pipes will impede the performance of any spouting system.

STEP 2 - INSTALLATION

• Be safe, use a stable platform or ladder.
• Choose the correct product size for the gutter profile.
• Internal corners of the spouting system are mostly cramped due to the valley tray protrusion from the roof into the gutter space.
• DO NOT squash the foam into the corner and underneath the valley tray.
• Cut the Foam to sit on the sides of the valley tray.
• Do not tuck the Foam underneath brackets.
• Go over or cut to fit between the brackets.
• For all corners, a mitre diagonal join is necessary to ensure good water flow.

NOTES: If your gutters have internal support brackets that are low in the gutters you may need to cut the underside of the GutterFoam with a sharp knife at the point of each internal bracket. The Foam will straddle the bracket.

TOOLS REQUIRED: Sharp box knife or a sharp kitchen knife & tape measure. Gloves are necessary to save your hands and fingers from being cut on the sharp edges of the roof and gutter.